The part(s) or condition(s) listed below for the symptom Refrigerator ice maker overflowing are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.
Top 7 Reasons Refrigerator Dispenser Isn’t Working?
Top 6 Reasons Refrigerator Ice Maker Isn’t Working?
Top 5 Reasons Refrigerator Is Leaking Water?
Top 6 Reasons Refrigerator Isn’t Cooling?
Top 5 Reasons Refrigerator Isn’t Defrosting?
Top 6 Reasons Refrigerator Runs Constantly?
Top 5 Reasons Refrigerator Is Freezing Food?
Top 5 Reasons Refrigerator Is Noisy?
How to Clean a Refrigerator Condenser Coil - Tech Tips from Repair Clinic
Wipe Refrigerator Gaskets - Tech Tips from Repair Clinic
Setting the Most Efficient Fridge Temperature - Tech Tips from Repair Clinic
Lubricate Refrigerator Gaskets - Tech Tips from Repair Clinic
Lubricate New Refrigerator Bushings - Tech Tips from Repair Clinic
5 Tips For Your Refrigerator - Tech Tips from Repair Clinic
Give the Fridge Some Space - Tech Tips from Repair Clinic
Refrigerator Light Not Working? Refrigerator TroubleshootingThe water inlet valve requires a minimum of 20 psi to shut off properly. If the water pressure is too low, the valve may not close fully once the power is shut off. As a result, the valve will leak water into the ice maker and cause the ice maker to overflow. Check the water pressure to determine if it is at least 20 psi. If the water pressure is sufficient, the water inlet valve is likely defective. The valve may not shut off all the way or may be stuck open, causing water to leak through the valve. If the water pressure is sufficient, but the ice maker is still overflowing, replace the water inlet valve.
If there are food items stuck in or jammed around the icemaker, it may not cycle properly. The ice maker may get stuck in the middle of a cycle or overflow with ice or water. Inspect the icemaker and remove any items that may interfere with its operation.
Ice Bucket Assembly
The water inlet valve supplies water to the refrigerator ice and water dispenser. The valve requires a minimum of 20psi to work properly. If the water pressure is too low, the valve may not close fully when the power is shut off. As a result, the valve leaks water into the ice maker, causing it to overflow. Check the water flow and test the pressure to determine if it is at least 20 psi.
One component of the ice maker assembly might be defective. Since many of the ice maker components are not sold separately, you may need to purchase and replace the entire ice maker assembly.
Auger Motor
Clip
Adhesive
