The part(s) or condition(s) listed below for the symptom Refrigerator dispenser leaking water are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.
Top 7 Reasons Refrigerator Dispenser Isn’t Working?
Top 6 Reasons Refrigerator Ice Maker Isn’t Working?
Top 5 Reasons Refrigerator Is Leaking Water?
Top 6 Reasons Refrigerator Isn’t Cooling?
Top 5 Reasons Refrigerator Isn’t Defrosting?
Top 6 Reasons Refrigerator Runs Constantly?
Top 5 Reasons Refrigerator Is Freezing Food?
Top 5 Reasons Refrigerator Is Noisy?
How to Clean a Refrigerator Condenser Coil - Tech Tips from Repair Clinic
Wipe Refrigerator Gaskets - Tech Tips from Repair Clinic
Setting the Most Efficient Fridge Temperature - Tech Tips from Repair Clinic
Lubricate Refrigerator Gaskets - Tech Tips from Repair Clinic
Lubricate New Refrigerator Bushings - Tech Tips from Repair Clinic
5 Tips For Your Refrigerator - Tech Tips from Repair Clinic
Give the Fridge Some Space - Tech Tips from Repair Clinic
Refrigerator Light Not Working? Refrigerator TroubleshootingThe dispenser door is opened by a motor or a solenoid to dispense the ice, but if the door is broken, it may not open properly in order to release the ice. You should inspect the dispenser door for damage to determine if the component should be replaced. You may have to remove the dispenser control panel or frame to access and inspect the dispenser door.
The home may have insufficient water pressure. The water inlet valve supplies water to the water dispenser. The water inlet valve requires a minimum of 20 psi to function properly. Check the water flow and test the pressure to determine if it is at least 20 psi.
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
A refrigerator water inlet valve will direct water to the dispenser as well as the ice maker fill tube. If the inlet valve is obstructed, the solenoid coils on the valve are defective, or the home's water pressure is too low, the water valve will not work properly. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.
