GE Dryer Parts

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

OEM Part - Manufacturer #WE1M504

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

OEM Part - Manufacturer #WE09X27634

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

OEM Part - Manufacturer #WE12X83

Front bulkhead assembly with moisture sensor bars.

OEM Part - Manufacturer #WE14X25080

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

OEM Part - Manufacturer #WE25M40

Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.

OEM Part - Manufacturer #WE04X25996

Dryer lint filter. Keeping the filter clean is vital to dryer operation.

OEM Part - Manufacturer #WE18X25100

This handy condenser brush can be used to clean the duct that the filter fits into.

Control knob, white

OEM Part - Manufacturer #WH1X2721

Light bulb, 120V, 10W

OEM Part - Manufacturer #WE05X20431

Dryer timer knob assembly in white with chrome accent ring and black indicator. The knob has a D shaped shaft and is 2-3/4 inches in diameter.

OEM Part - Manufacturer #WE1M654

If the knob insert is damaged or missing a new insert should be ordered in the knob.

Handle, white. Snaps in place

OEM Part - Manufacturer #WE01X20419

Door switch

OEM Part - Manufacturer #WE4M415

Door strike

OEM Part - Manufacturer #WE1X1192