GE Dryer Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

Set of two drum rollers. Includes the roller shaft and mounting clips.As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

OEM Part - Manufacturer #AGM75510755

If the old retainer is missing or damaged a new retainer should be ordered.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

OEM Part - Manufacturer #WE1M504

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #4400EL2001F

Dryer drum slide, white

OEM Part - Manufacturer #WE3M51

Lint Filter with Frame

OEM Part - Manufacturer #WE03X23881

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.

OEM Part - Manufacturer #6931EL3003D

Consider replacing the high limit thermostat too as it may also be defective.

Timer knob

OEM Part - Manufacturer #WE01X24552

The GE Appliances Front Drum Support Bearing WE3M26 is a high-quality part that allows the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. It is also called the Drum Glide Bearing. Disconnect the appliance from all utilities prior to installation.

OEM Part - Manufacturer #WE3M26

Dryer timer knob, white.

OEM Part - Manufacturer #WE1M652

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

OEM Part - Manufacturer #WE09X27634

Push to start switch

OEM Part - Manufacturer #WE4M416

This is a Genuine Replacement Part, The Model Number and Name for The Following Item: General Electric (GENF0) 40A15 40WATT 15AMP light bulb.

OEM Part - Manufacturer #40A15