Inglis Dryer Parts

Door catch

OEM Part - Manufacturer #WPW10610880

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

OEM Part - Manufacturer #WP3977767

The part may look different than the original but the part will still install and work the same.

The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.

OEM Part - Manufacturer #279311

Consider replacing the gas valve coils while you have the dryer apart.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

OEM Part - Manufacturer #WP8577274

Dryer heating element. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.

OEM Part - Manufacturer #WP8544771

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

OEM Part - Manufacturer #279973

Dryer timer assembly

OEM Part - Manufacturer #WPW10185982

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

OEM Part - Manufacturer #W10120998

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

OEM Part - Manufacturer #WP694089

Dryness sensor bar

OEM Part - Manufacturer #WP3387223

High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.

OEM Part - Manufacturer #W11050897

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

OEM Part - Manufacturer #279640

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

White Touch Up Paint

OEM Part - Manufacturer #72017