Dryer Parts

Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

OEM Part - Manufacturer #134503600

Consider replacing the bearing while the dryer is apart.

Dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

OEM Part - Manufacturer #DC97-16782A

Idler pulley for dryer drum drive belt

OEM Part - Manufacturer #WP691366

Consider replacing the Drive Belt while you have the dryer apart.

Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.

OEM Part - Manufacturer #W10721967

The drive belt wears out over time. You may want to replace the drive belt while the washer is apart.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

OEM Part - Manufacturer #WE1M504

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #WPY312959

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Dryer door catch kit

OEM Part - Manufacturer #279570

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

OEM Part - Manufacturer #WPW10717210

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer drum drive motor with pulley

OEM Part - Manufacturer #279827

Dryer drum drive belt

OEM Part - Manufacturer #WP40111201

Light module, led

OEM Part - Manufacturer #W11602886

Door catch

OEM Part - Manufacturer #WPW10610880