Washer/Dryer Combo Parts

Cover,outlet

OEM Part - Manufacturer #D518524

Motor pulley, 60 hertz

OEM Part - Manufacturer #WP8066184

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

OEM Part - Manufacturer #WP3390719

Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts

Aftermarket (Non-OEM) Part - Manufacturer #TB123B

Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.

OEM Part - Manufacturer #3949247V

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

The GE Appliances Front Drum Support Bearing WE3M26 is a high-quality part that allows the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. It is also called the Drum Glide Bearing. Disconnect the appliance from all utilities prior to installation.

OEM Part - Manufacturer #WE3M26

Whirlpool's transmission is a genuine replacement part for washing machines that ensures optimal turning motion for the drum, resulting in the best wash possible for clothes.

OEM Part - Manufacturer #3360629

The drive coupler can wear out significantly over time. Consider replacing the drive coupler while you have the washer apart.

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Clutch

OEM Part - Manufacturer #WH05X24185

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

The fuse can be tested using a multimeter meter

Push to start switch

OEM Part - Manufacturer #WE4M416

Washing machine agitator repair kit with a short length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

OEM Part - Manufacturer #285809

If the bolt is stripped, it should be replaced.

Agitator Bolt

OEM Part - Manufacturer #WP358237