Thermal Zone Parts (500 results)

2.8 oz Tube of Red Devil High Temp RTV Silicone. Perfect for Gasket replacement. Not for Heat Exchangers.

Manufacturer #93247

Apply a small beed around inducer housings, flanges or anywhere metal touches metal, or where a gasket is normaly used.

Hot surface igniter

OEM Part - Manufacturer #62-22868-93

Contactor, 24 volts, 30 amps, 1pole

OEM Part - Manufacturer #42-25101-01

Furnace Control Board

OEM Part - Manufacturer #903106

Limit switch, L350F manual reset

OEM Part - Manufacturer #47-22861-01

Run Capacitor 370 Volts Round Dual 45/5 MFD

OEM Part - Manufacturer #43-25133-06

Please note that the shape (Round/Oval-Flat) only matters for mounting purposes.

Run Capacitor 370 Volts Round Dual 40/5 MFD

OEM Part - Manufacturer #43-25133-44

Please note that the shape (Round/Oval-Flat) only matters for mounting purposes.

Condensate Trap

OEM Part - Manufacturer #68-24048-01

Induced draft blower motor with gasket, 120 volts

OEM Part - Manufacturer #70-24033-01

To prevent carbon monoixde from leaking into your home we recommend replacing the draft inducer gasket when servicing the motor or inducer blower wheel. If you do not have a new gasket or it does not come with the replacmeent part you can use high temperature silicone sealant to prevent exhuast from leaking into your home .

Blank center cap nameplate

OEM Part - Manufacturer #91-101123-00

Transformer, 120 Volts Primary, 24 Volt Secondary, 40VA

OEM Part - Manufacturer #46-101496-01

24v 40amp 1pole contactor

OEM Part - Manufacturer #42-25101-03

3/4HP 115Volts 60Hz 9.5 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3.75" Shaft

OEM Part - Manufacturer #51-25023-01