Montgomery Wards Parts

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

Oven sensor kit, short 3" long

OEM Part - Manufacturer #12001655

The 5303281135 radiant sensor is an OEM part for dryers that monitors the igniter's temperature to ignite gas and light the burner. It is compatible with various brands and requires installation with work gloves and unplugging the dryer.

OEM Part - Manufacturer #5303281135

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.