Hotpoint Dryer Parts

Dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time. If the dryer belt cracks or breaks, the dryer drum will not be able to turn. If the dryer motor is running, but the drum won't rotate, the belt has likely broken.

OEM Part - Manufacturer #WE12X10014

Dryer door catch kit

OEM Part - Manufacturer #WE1M1011

Dryer motor kit. Replaces old "T" & "V" style motors. Includes 2 motor pulleys and basic directions. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at al

OEM Part - Manufacturer #WE17X10010

Note that wiring will differ from original motor and might need to be installed by an appliance repair person.

Knob clip, also called an insert. If the clip is missing from the knob check on the control stem.

OEM Part - Manufacturer #WH01X10106

The GE Appliances Blower Wheel WE16M15 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It replaces multiple part numbers. When repairing use caution.

OEM Part - Manufacturer #WE16M15

The Genuine OEM GE Appliances Idler Pulley Wheel WE12X81 maintains proper tension on the drive belt to spin the drum. It comes with a spacer and retainer clip and should be installed with the appliance disconnected from all utilities.

OEM Part - Manufacturer #WE12X81

This is a Genuine Replacement Part, The Model Number and Name for The Following Item: General Electric (GENF0) 22-WE4X584 Thermostat - was WE4X584.

OEM Part - Manufacturer #WE4X584

The GE Rear Drum Support Bearing WE3X75 is a high quality OEM part that ensures smooth and quiet rotation of the drum. It measures approximately 1 inches x 1 inches x 0.75 inches and it is recommended to disconnect the appliance before installation.

OEM Part - Manufacturer #WE3X75

Dryer belts dry out over time and can eventually crack or break. We recommend replacing the dryer belt while the dryer Is apart.

The GE Appliances Blower Wheel Retainer Assembly WE1X688 is a high-quality part that attaches the blower wheel to the drive motor shaft. It replaces multiple part numbers and should only be installed by a trained service professional after disconnecting the appliance from all utilities.

OEM Part - Manufacturer #WE1X688

12 Pack Of Screws

OEM Part - Manufacturer #WE2X263D

Screw

OEM Part - Manufacturer #WH2X930

Motor pulley with set screw

OEM Part - Manufacturer #WE12X41

Grounding strap, drum shaft

OEM Part - Manufacturer #WE1X1172