Kenmore Dryer Parts

Plastic leveling leg. White approximately 1" round x 1 3/4" long

OEM Part - Manufacturer #49621

Dryer drum rear felt seal kit with adhesive.

OEM Part - Manufacturer #W10612022

Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.

OEM Part - Manufacturer #WPW10547292

Motor pulley, 60 hertz

OEM Part - Manufacturer #WP8066184

Light Bulb

OEM Part - Manufacturer #WPA3073101

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

OEM Part - Manufacturer #WP3390719

Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.

OEM Part - Manufacturer #3949247V

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Timer

OEM Part - Manufacturer #WPW10185992

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

The fuse can be tested using a multimeter meter

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

OEM Part - Manufacturer #W10909685

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

OEM Part - Manufacturer #WE09X27634

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 349639 Lint Screen.

OEM Part - Manufacturer #WP349639

Use this brush to clean the dryers venting.