Whirlpool Dryer Parts

Dryer Maintenance Kit 4392067 includes various replacement parts like drum support rollers, a multi-rib belt, an idler pulley wheel, triangle clips, and a washer. The kit is compatible with Whirlpool, Kenmore, and Maytag dryers and addresses issues like unusual noises and drum support problems.

OEM Part - Manufacturer #4392067

Dryer idler pulley assembly. Includes bracket and attached pulley

OEM Part - Manufacturer #W10837240

Consider replacing the belt while the dryer is apart.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #WPW10314173

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #349241T

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

OEM Part - Manufacturer #WP3387747

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #661570V

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

OEM Part - Manufacturer #WP8577274

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

OEM Part - Manufacturer #279973

Dryness sensor bar

OEM Part - Manufacturer #WP3387223

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

OEM Part - Manufacturer #279640

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

OEM Part - Manufacturer #WP3390719

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

OEM Part - Manufacturer #W10909685

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

OEM Part - Manufacturer #WP697772