JC Penney Dryer Parts

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

OEM Part - Manufacturer #WE25M40

Dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time. If the dryer belt cracks or breaks, the dryer drum will not be able to turn. If the dryer motor is running, but the drum won't rotate, the belt has likely broken.

OEM Part - Manufacturer #WE12X10014

Terminal block for main power supply or cord

OEM Part - Manufacturer #5304409888

Dryer door catch kit

OEM Part - Manufacturer #WE1M1011

Flame sensor at side of burner tube

OEM Part - Manufacturer #WE4X448

Dryer motor kit. Replaces old "T" & "V" style motors. Includes 2 motor pulleys and basic directions. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at al

OEM Part - Manufacturer #WE17X10010

Note that wiring will differ from original motor and might need to be installed by an appliance repair person.

The GE Appliances Blower Wheel WE16M15 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It replaces multiple part numbers. When repairing use caution.

OEM Part - Manufacturer #WE16M15

The Genuine OEM GE Appliances Idler Pulley Wheel WE12X81 maintains proper tension on the drive belt to spin the drum. It comes with a spacer and retainer clip and should be installed with the appliance disconnected from all utilities.

OEM Part - Manufacturer #WE12X81

This is a Genuine Replacement Part, The Model Number and Name for The Following Item: General Electric (GENF0) 22-WE4X584 Thermostat - was WE4X584.

OEM Part - Manufacturer #WE4X584

The GE Rear Drum Support Bearing WE3X75 is a high quality OEM part that ensures smooth and quiet rotation of the drum. It measures approximately 1 inches x 1 inches x 0.75 inches and it is recommended to disconnect the appliance before installation.

OEM Part - Manufacturer #WE3X75

Dryer belts dry out over time and can eventually crack or break. We recommend replacing the dryer belt while the dryer Is apart.

The GE Appliances Burner Igniter WE4X444 is a high-quality replacement part for gas-fueled dryers. It lights the gas burner to heat the dryer during the cycle and replaces several part numbers. Disconnect the appliance from all utilities prior to installation.

OEM Part - Manufacturer #WE4X444

Motor pulley with set screw

OEM Part - Manufacturer #WE12X41

This is a Genuine Replacement Part, The Model Number and Name for The Following Item: General Electric (GENF0) WH1X484 Leveling Leg Pad.

OEM Part - Manufacturer #WH1X484