Simplicity Wood Chipper Parts

Briggs & Stratton Spark Plug (RJ19LM). If the engine does not start or runs poorly then the spark plug may be defective and will need replacement.

Genuine OEM Part - Manufacturer #796112S

Briggs & Stratton in-line fuel filter. The filter screen is on the large side of the housing. The port on the large side goes to the fuel tank while the port on the small side of the housing goes to the carburetor.

Genuine OEM Part - Manufacturer #394358S

Small engine recoil starter assembly. This item includes the pulley and spring. The recoil starter engages the drive cup on the flywheel to start the engine when pulled.

Genuine OEM Part - Manufacturer #498144

Briggs & Stratton in-line fuel filter. If the fuel filter is clogged, it will restrict the flow of fuel to the carburetor. As a result, the engine may not start.

Genuine OEM Part - Manufacturer #298090S

Briggs & Stratton flywheel key. The flywheel key aligns the flywheel in the correct position on the crankshaft. If the engine stops suddenly due to hitting a hard object, the flywheel key shears in half to prevent damage to the engine. If the flywheel key is broken, the engine won't start.

Genuine OEM Part - Manufacturer #222698S

Briggs & Stratton breather tube grommet.

Genuine OEM Part - Manufacturer #692189

Genuine Briggs & Stratton 495606 Carburetor Rebuild Kit. If the engine is running poorly then the carburetor may be restricted and need to be cleaned and some of the internal seals and diaphragm replaced.

Genuine OEM Part - Manufacturer #495606

Gasket-float bowl

Genuine OEM Part - Manufacturer #281165S

Mating surfaces must be clean and dry before installing this gasket. Do not use solvents or gasket sealer on this gasket.

Spark plug boot

Genuine OEM Part - Manufacturer #66538S

Briggs ignition coil kit to replace points & condenser. 5 HP Horizontal & Vertical Series 550

Genuine OEM Part - Manufacturer #397358

Briggs & Stratton Original Equipment 100005 4 Cycle Oil. (18oz Bottle) Briggs & Stratton Lawn Mower Oil is formulated for 4-cycle air-cooled engines. Don't overfill the crankcase when adding oil. Too much oil can damage the engine.

Genuine OEM Part - Manufacturer #100005

For optimum performance, you should change the oil in your small engine after the first five hours of use and then annually, or every 50 hours of use (whichever comes first).

Fuel inlet hose connector

Genuine OEM Part - Manufacturer #692317

Check plastic for cracks. Replace as necessary. This fitting is pressed into the carburetor body.

Oil seal, magneto side

Genuine OEM Part - Manufacturer #391086S