Crosley Washer/Dryer Combo Parts

Whirlpool's transmission is a genuine replacement part for washing machines that ensures optimal turning motion for the drum, resulting in the best wash possible for clothes.

OEM Part - Manufacturer #3360629

The drive coupler can wear out significantly over time. Consider replacing the drive coupler while you have the washer apart.

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

The fuse can be tested using a multimeter meter

Agitator Bolt

OEM Part - Manufacturer #WP358237

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

OEM Part - Manufacturer #WP697772

Dryer drum felt seal kit. Includes silicone rubber adhesive.

OEM Part - Manufacturer #280114

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

OEM Part - Manufacturer #279457

Washing machine tub counterbalance spring. This spring offsets the weight of the motor on the front of the washer. If broke, the tub will lean forward and the tub will be off balance during the spin cycle.

OEM Part - Manufacturer #WPW10250667

Door lock & switch assembly

OEM Part - Manufacturer #131763256

Make sure the door strike is not damaged.

Outer grille

OEM Part - Manufacturer #W11086603

Washing machine main tub seal

OEM Part - Manufacturer #W10814296

If this seal fails water will leak out from the underside of the plastic outer tub.

The felt door seal is a replacement part for dryers that ensures proper heat retention during the drying process. It is easy to install and helps to keep the contents of the dryer warm, dry, and cozy.

OEM Part - Manufacturer #5303937183

Screw

OEM Part - Manufacturer #WP308685