Kenmore Range/Stove/Oven Parts

Oven temperature sensor

OEM Part - Manufacturer #316490000

Oven temperature sensor *May require cutting and splicing wire connector from old sensor onto new sensor with porcelain wire nuts

OEM Part - Manufacturer #316233903

Oven temperature sensor kit, 6 inches long. The sensor includes two wire harness adapters for a variety of applications and installation instructions.

OEM Part - Manufacturer #12001656

Oven temperature sensor

OEM Part - Manufacturer #316217002

Oven temperature sensor

OEM Part - Manufacturer #W10833885

Oven sensor

OEM Part - Manufacturer #WB21X22134

Oven sensor. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.

OEM Part - Manufacturer #EBG61305805

Oven sensor kit, short 3" long

OEM Part - Manufacturer #12001655

Oven sensor *Connector could be different than original. If so cut & splice wires together with porcelain wire nuts.

OEM Part - Manufacturer #316490001

Oven temperature sensor assembly. *** If the old plug is different kit comes with high temp ceramic notes to splice in*** The oven sensor works in conjunction with the oven control board to regulate the oven temperature. If the oven sensor is defective, the oven temperature will be inaccurate.

OEM Part - Manufacturer #WB21X5301

This is a Genuine Replacement Part, The Model Number and Name for The Following Item: General Electric (GENF0) WB23T10015 Range/stove/oven Sensor.

OEM Part - Manufacturer #WB23T10015

Oven temperature sensor. This part may be different than your original. Instructions are included to help with the repair. See below for a brief set of instructions

OEM Part - Manufacturer #5304497424

These instructions only apply if the connector piece is different than your original.<br>Prior to cutting the leads, please check the length of the wire you need.<br>1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.<br>2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.<br>3. Twist the ends of your new probe and original connector together<br>4. Use a wire nut, or another high heat fastener to cover your exposed wires.<br>5. Install your new oven probe and re assembly your oven.

Meat probe

OEM Part - Manufacturer #5304504202