Kenmore Washing Machine Parts

Washing machine mode shift actuator. *Updated by the manufacturer, does not look like original part. Actuator serves several functions. It has a synchronous motor that shifts the splutch cam ring and monitors the position of the splutch. Also has transmission speed/position optical sensor

OEM Part - Manufacturer #WPW10006355

Consider replacing the washer drive belt while you have the washer apart.

Includes latch assembly, one white and one gray lid lock bezel. Lid must be closed for washer to fill, wash, drain, or spin. If the machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.

OEM Part - Manufacturer #W10404050

Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.

OEM Part - Manufacturer #3949247V

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Clutch Slider Gear Assembly

OEM Part - Manufacturer #W10734521

Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts

Aftermarket (Non-OEM) Part - Manufacturer #TB123B

Whirlpool's transmission is a genuine replacement part for washing machines that ensures optimal turning motion for the drum, resulting in the best wash possible for clothes.

OEM Part - Manufacturer #3360629

The drive coupler can wear out significantly over time. Consider replacing the drive coupler while you have the washer apart.

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Washing machine door boot gasket with drain port. If the door boot is torn, the washer will leak water. The most common cause of a torn door boot is if the washer is overloaded. Be aware that your model may also list a door boot without drain port. Be sure to check the original part before ordering.

OEM Part - Manufacturer #4986ER0004F

If the washer starts to smell we recommend using Affresh once a month.

Lid lock assembly

OEM Part - Manufacturer #W10810403

Water inlet valve and inlet assembly with thermistor for water temp sensing. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

OEM Part - Manufacturer #WPW10144820

Agitator Bolt

OEM Part - Manufacturer #WP358237

Washing machine pulsator assembly (or wash plate) with screw.

OEM Part - Manufacturer #AGZ72909711

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Door lock & switch assembly

OEM Part - Manufacturer #131763256

Make sure the door strike is not damaged.