LG Washing Machine Model WM2277HW Parts

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

OEM Part - Manufacturer #5220FR2006H

Consider replacing the old fill hose when installing a new valve.

Washer cold water inlet valve assembly. Three solenoids. Hot water valve is a separate single coil valve and can be found in related parts

OEM Part - Manufacturer #5220FR2075L

Washing machine rotor position sensor assembly. This part is also called a hall sensor or motor sensor. When this part fails the control may display an LE error code.

OEM Part - Manufacturer #6501KW2002B

Washing machine door boot gasket with drain port. If the door boot is torn, the washer will leak water. The most common cause of a torn door boot is if the washer is overloaded. Be aware that your model may also list a door boot without drain port. Be sure to check the original part before ordering.

OEM Part - Manufacturer #4986ER0004F

If the washer starts to smell we recommend using Affresh once a month.

Tub bearing. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

OEM Part - Manufacturer #4280EN4001C

Washer door lock latch assembly. The door lock secures the washer door shut during operation. Once the washing machine door is closed, the washer can begin operating. If the door lock is defective, the washer door will not latch properly.

OEM Part - Manufacturer #EBF49827801

Washer tub bearing, rear. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

OEM Part - Manufacturer #MAP61913707

Washing machine tub seal. If the washing machine is leaking water from above the transmission, this seal is likely damaged or worn out.

OEM Part - Manufacturer #4036ER2004A

Hose

OEM Part - Manufacturer #4738ER1004B

Washing machine tub seal. Located between the front outer tub and rear outer tub. If the washing machine is leaking water from between these two tubs, this seal is likely damaged or worn out.

OEM Part - Manufacturer #4036ER4001B

The tub seal and bearing should be replaced at the same time.

Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.

OEM Part - Manufacturer #4738ER1002A

If your washing machine has a moldy or musty odor, we recommend cleaning it with Affresh washing machine cleaner.

Washing machine door boot clamp for front panel.

OEM Part - Manufacturer #2W20017E

If your washer has an unpleasant odor than we recommend using Affresh washing machine cleaner.

Water level pressure switch

OEM Part - Manufacturer #6601ER1006E