Small Engine Accessories

Kawasaki Original Equipment 4 Cycle Engine Oil 10W30 32 oz.(1 Quart). Kawasaki KTECH 4-cycle oil is enhanced with Anti-Foaming and Anti-Sheer agents, along with other additives

Genuine OEM Part - Manufacturer #99969-6081

For optimum performance, you should change the oil in your small engine after the first five hours of use and then annually, or every 50 hours of use (whichever comes first). Kawasaki Small Engine Oil is formulated for 4-cycle air-cooled engines. Don't overfill the crankcase when adding oil. Too much oil can damage the engine

Cycle oil, 3.2 oz. bottle of ashless oil formulation with fuel stabilizer. Leaves no residue-prevents fouling and engine deposits.

Genuine OEM Part - Manufacturer #100107

Large flywheel puller with 2 & 13/16" bolt spacing. See related items for other sizes.

Genuine OEM Part - Manufacturer #19203

Small Flywheel puller with bolt spacing of 1 & 5/8". See related items for other sizes.

Genuine OEM Part - Manufacturer #19069

Starter clutch wrench.
This wrench is to be used with a 7/8 inch socket to install, remove, or torque starter clutches both quickly and easily.

Genuine OEM Part - Manufacturer #19244

Bendix Starter Lubricant

Genuine OEM Part - Manufacturer #52 357 01-S

Ignition Output Tester (all except capacitive discharge engines). Fires at 12kV.

Genuine OEM Part - Manufacturer #2545501-S

Loctite® Instant Gasket. Makes reliable gaskets in one minute. Oil and coolant resistant. Non-corrosive and non-slumping. Ideal for use on timing gear covers, gearboxes, compressors, stamping sheet metal covers, intake manifold end seals, water pumps, valve covers, and transmission pans.

Genuine OEM Part - Manufacturer #25 597 07-S

Valve spring compressor

Genuine OEM Part - Manufacturer #19063

Tachometer (Treysit Sirometer)
This part is used to determine the RPMs of your engine. It measures from 800 to 25,000 revolutions per minute and can work on any small engine.

Genuine OEM Part - Manufacturer #19200

19435 C-Ring Installation Tool
Installing new C-ring on starter motor when replacing starter motor drive gear.

Genuine OEM Part - Manufacturer #19435

19522 C-Ring Removal Tool
For removing C-ring on starter motor when replacing starter motor drive gear.

Genuine OEM Part - Manufacturer #19522

Medium Flywheel Puller with 2" bolt spacing. See related items below for other sizes.

Genuine OEM Part - Manufacturer #19165