GO
SEARCH:

Cub Cadet Generator Runs Rough

The part(s) or condition(s) listed below for the symptom Generator runs rough are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Generator runs rough

For the most accurate results, enter your model number.


Cause 1Carburetor

The carburetor might be clogged. A clogged carburetor is most often due to leaving fuel in the generator for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall or run roughly. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.

Parts
Cause 2Carburetor Repair Kit

The carburetor might be clogged. A clogged carburetor is most often due to leaving fuel in the generator for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall or run roughly. If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.

Parts
Cause 3Spark Plug

Inspect the spark plug for signs of wear or damage. If the porcelain insulator is cracked, an electrode is burned away or damaged, or there is heavy carbon buildup at the electrode, replace the spark plug. To determine if the spark plug is defective, use a spark plug tester. You should see a strong spark between the tester’s terminals when the engine is cranking. If there is no spark, this indicates that the spark plug is defective and should be replaced.

Parts
Cause 4Fuel Filter

If the chainsaw runs poorly, the fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the chainsaw. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to stall or run roughly. If old fuel was left in the chainsaw, drain the old fuel from the fuel tank and replace the fuel filter.

Parts