GO
SEARCH:

Emerson Air Conditioner Not Blowing Enough

The part(s) or condition(s) listed below for the symptom Air conditioner not blowing enough are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page.

Most Frequent Causes for Air conditioner not blowing enough

For the most accurate results, enter your model number.


Cause 1Condenser Fan Motor

To determine if the condenser fan motor is working, use a multimeter to test the incoming voltage to the motor. If the condenser fan motor is receiving the correct voltage, but the motor still won’t run, you should inspect the capacitor, if applicable, for any bulging or leaking. You can also use a multimeter to determine if the capacitor can hold and release its charge. If the capacitor appears to be in good condition, replace the condenser fan motor.

Parts
Cause 2Dual Shaft Fan Motor

An air conditioner dual shaft fan motor is the component that spins both the condenser fan blade in the rear of the unit and the fan blade that forces the cooled air out the front vent. If the fan motor is burned out, the unit will not be able to blow enough air. You can use a multimeter to determine if power is reaching the fan motor. If power is reaching the motor, but it doesn't run, the component will need to be replaced.

Parts
Cause 3Fan Motor

An air conditioner fan motor is the component that spins the fan blade or blower wheel to circulate the air. If one of the fan motors is burned out, the unit will not be able to blow enough air. You can use a multimeter to determine if power is reaching the fan motor. If power is reaching the motor, but it doesn't run, the component will need to be replaced.

Parts
Cause 4Clogged or Restricted Coils

Both the indoor and outdoor coils need to be clear for the air conditioner to work efficently. A clogged or restricted coil will reduce air flow causing the unit to run longer. If the coils are clogged or restricted they will need to be cleaned.

Cause 5Air Filter

If the air filter is clogged, air cannot flow properly through the air conditioner. This greatly reduces the cooling capacity of the air conditioner. In addition, if the air filter is clogged, the evaporator coils will frost over. To remove debris from the air filter, try cleaning the filter. If it is not possible to clean the air filter, replace it.

Parts
Cause 6Dirty Air Filter

If the air filter becomes clogged with dirt, it restricts air flow over the evaporator coils. If the air flow is reduced, the evaporator coils get too cold, which then causes the humidity in the room to condense on the coils and freeze. As frost accumulates on the coils, the frost restricts the air flow even more. Eventually, the entire evaporator coil assembly will frost over, causing the air flow to be completely restricted. If the air filter is dirty, replace it.