GE Dishwasher Parts

Roller and axle assembly for lower dishrack.Used for rear rollers on some models.Some models use these rollers for the front and rear.

OEM Part - Manufacturer #WD35X21038

Because these rollers generally wear out at the same time, we recommend replacing them in pairs.

Door corner baffle seal, left side

OEM Part - Manufacturer #WD8X228

For the right-hand baffle, order part 2364.

Plunger and armature, drain solenoid

OEM Part - Manufacturer #WD1X1316

Rack slide end cap for upper dishrack. This end cap prevents the dishrack from sliding all the way out of the dishwasher.

OEM Part - Manufacturer #WD12X10304

If your dishwasher has an unpleasant odor, we recommend cleaning it with Affresh dishwasher cleaner. This cleaner also improves dishwasher performance by removing soap buildup.

Dishwasher motor and pump kit. Note: This part may not look like your old motor and pump assembly. It is a new kit designed by the manufacturer to replace all of their dishwasher pumps since 1970. Instructions for adapting it to your dishwasher model are included.

OEM Part - Manufacturer #WD26X10013

Dishwasher lower dishrack assembly.Comes with 6 rollers and supports

OEM Part - Manufacturer #WD28X31819

Dishwasher dishrack roller kit, set of 4. These rollers allow the dishrack to move in and out of the dishwasher.

OEM Part - Manufacturer #WD12X10327

If your dishwasher has an unpleasant odor, we recommend cleaning it with Affresh dishwasher cleaner. This cleaner also improves dishwasher performance by removing soap buildup.

This is a genuine replacement part. The model number and name for the following item is: General Electric WD8X181 Shaft Seal.

OEM Part - Manufacturer #WD8X181

This is a genuine replacement part. The model number and name for the following item is: General Electric WD18X213 Inlet Sump.

OEM Part - Manufacturer #WD18X213

This high quality Genuine OEM GE Appliances Door Gasket Insert (WD08X10015) attaches at the bottom of the door seal to hold the gasket in place . The Door Gasket Insert is also called the Door Seal Insert. Please be aware that it is recommended to disconnect the appliance from all utilities prior t

OEM Part - Manufacturer #WD08X10015

Hinge arm link

OEM Part - Manufacturer #WD14X10009

The GE Appliances Check Valve Piston WD24X10018 prevents water from flowing back into the tub and fits inside the check valve body. It is recommended to use safety equipment and disconnect the appliance before any repair. Consult the owner's manual for part numbers and repair instructions.

OEM Part - Manufacturer #WD24X10018

Push On Nut

OEM Part - Manufacturer #WR2X7054