Refine Selection Here:
This part fits your Furnace
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
OEM Part - Manufacturer #SEN01114
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Stainless steel burner
OEM Part - Manufacturer #BNR01077
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
HSI control module with four wire leads
OEM Part - Manufacturer #CNT07941
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Flame rollout switch. Push red button to reset. L310
OEM Part - Manufacturer #SWT02173
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount
OEM Part - Manufacturer #TRR01729
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Hot surface furnace ignitor with plug on connector
OEM Part - Manufacturer #IGN00054USA
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Thermal limit switch, open at 190 degrees, close at 160 degrees
OEM Part - Manufacturer #SWT01612
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Blower Wheel 11.7 by 10.6 inches.
OEM Part - Manufacturer #WHL03116
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Draft inducer motor, one stage with shaded pole motor *Note: All models use this part with the exception of: *UX/DX100A, UX/DX100C, UX/DX1C100, UX1D100, UX/DX120A, UX/DX120C. These select models use item 2458691.
OEM Part - Manufacturer #BLW00864
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Door switch, 21 amps, 125/250 vac
OEM Part - Manufacturer #SWT01714
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Capacitor; 440 vac oval motor run, 15 mfd
OEM Part - Manufacturer #SFCAP15440
This part fits your Furnace
Pressure switch
OEM Part - Manufacturer #SWT02514
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Brass orifice spud, drill #45
OEM Part - Manufacturer #ORF01427
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Reverse flow open 105f, close 95f, 120/240v
OEM Part - Manufacturer #SWT01649
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Furnace
Blower motor, 3/4HP, 115 volts, 60 hertz, 9.6 amps 1075 RPM's, 4 Speed Open Enclosure, 48Y Frame, Single Phase CCW 3" Shaft
OEM Part - Manufacturer #MOT18950